The DCC80 Autofrog is a simple switch that automatically changes the frog polarity on your DCC layout. In most situations, the use of electrofrog points is recommended on digital layouts to ensure reliability but this can make extra switching more complicated than it needs to be. There are three solder connections on the board, 2 connections labelled “R” - which should be connected to the rails or bus and 1 connection labelled “F” which can be connected to the frog input wire.

Big soundbox.

Retaining clip.

Taktgeber-Set

Pre-configured decoder for RENFE (444) Railcars (Electrotren).

Trix 66835 Lokdecoder, 600 mA

Zimo MX9AZNG Aufsteckplatine für MX9

Tomytec 975068 Fahrtregler, N-1001 CL

Decoder E24 nach NEM 664

Z21 WLANMAUS newGen

Z21 Profi Digital Set with Z21 WLANMAUS newGen

Z21 START newGen Basic Digital Set

Sound Decoder with NEM 658 22-pin PLUX22 interface, 30 x 15 x 4 mm, audio 3 W (4 ohms), 13 Connection wires (2 x rail, 2 x motor, acc. Plus, mass, Elko Plus, 4 FU outputs , 2 x speakers), 6 solder pads (other FU outputs), direct connection energy storage 15 V (unlimited capacity) on Plux pin strip.Played with a sound project for the bwegt Desiro HC.

Sound Decoder with NEM 658 22-pin PLUX22 interface, 30 x 15 x 4 mm, audio 3 W (4 ohms), 13 Connection wires (2 x rail, 2 x motor, acc. Plus, mass, Elko Plus, 4 FU outputs , 2 x speakers), 6 solder pads (other FU outputs), direct connection energy storage 15 V (unlimited capacity) on Plux pin strip.Played with a sound project for the bwegt Desiro HC.

Sound decoder for RENFE Railcars (Series 444) by Electrotren.

Z21 START newGen Basic Digital Set

Z21 WLANMAUS newGen

Z21 Profi Digital Set with Z21 WLANMAUS newGen

ILLUMATIK 14-channel house lighting control for model railway buildings

Faller 180729 Rauchgenerator

The WD1C DCC Turnout Decoder enables digital control of Märklin and Trix C-track turnouts directly via the DCC digital system. Thanks to its compact design, the decoder is specifically designed for direct installation in numerous C-track turnouts and is therefore ideal for retrofitting existing turnouts with digital control.Setup is particularly straightforward: No complex CV programming is required. To assign the desired turnout address, simply press the PROG button briefly and then set the cor

Sound decoder for RENFE Railcars (Series 444) by Arnold, Next18.

Peco PL12X Weichenmotor-Adapterbasis ohne Übertrieb

Peco PL10 Weichenmotor alle Spurweit.